<big id="b3lxl"></big>

          <big id="b3lxl"></big>

          <cite id="b3lxl"><pre id="b3lxl"></pre></cite>
          banner

          Analysis pick and place machine?failure

          263 Published by Vivian 11 18,2019

          Today, I will? Analysis pick and place?machine failure

          First, the smt pick and place?machine component placement offset, mainly refers to the component placement on the PCB, the position shift in X-Y, the reasons for its occurrence are as follows:

          pick and place?machine failure

          1. the reason for the PCB board

          a: The bending of the PCB is beyond the allowable range of the device. The upturn is up to 1.2MM and the downturn is up to 0.5MM.

          b: The height of the support pins is inconsistent, resulting in uneven printing of the printed board.

          c: poor flatness of the workbench support platform

          d: Board technology and board layout are low in accuracy and poor in consistency. In particular, the difference between batch and batch is large.

          pick and place?machine failure

          1. The blowing pressure is abnormal when placing.
          2. The suction pressure of the mounting nozzle is too low, and the pick-up and placement should be above 400mmHG.

          4. Adhesives, soldering techniques and solder paste coatings are abnormal or deviating. This causes the component to drift when the pick and place component is mounted or when it is soldered. Too little causes the component to deviate from the original position when the device is mounted at high speed after the device is mounted. The coating position is inaccurate and the corresponding offset occurs due to the tension.

          pick and place?machine failure

          1. The program data device is incorrect.
          2. The substrate is poorly positioned.
          3. The coupling between the power piece and the transmission part of the X-Y table is loose.
          4. When the mounting nozzle rises, the movement is not smooth and slow.
          5. The mounting head nozzle is not properly installed.
          6. The blowing timing does not match the timing of the pick and place head.
          7. The initial data setting value of the camera of the nozzle center data and the optical recognition system is poor.

          when??pick and place machine?failure appear, you need to Analysis the reason and solve it.

          How to choose used smt pick and place machine supplier

          How to choose used smt pick and place machine supplier? Many customers are curious about the ways...

          Do you like ? 242

          Read more

          How to choose used FUJI pick and place machine supplier

          How to choose used FUJI pick and place machine supplier How to choose the right? FUJI pick and pl...

          Do you like ? 232

          Read more

          SMT nozzle manufacturer for pick and place machine

          SMT nozzle manufacturer for pick and place machine Nozzle Requirements for SMT companies Economi...

          Do you like ? 213

          Read more

          Used smt euipment Juki RS-1 pick and place machine

          Used smt equipment---Juki RS-1 pick and place machine Fast Smart Modular Juki?RS-1 pick and place...

          Do you like ? 217

          Read more

          Some famous smt pick and place machine manufacturers

          Today, I'm going to introduce some famous smt pick and place machine manufacturers. 1. Juki 2. Fu...

          Do you like ? 183

          Read more

          飞艇信誉计划群